Linux Mint Forums

Just curious: Is there a way to enable, on my Acer Aspire One, the two-finger scroll and right-click behavior that Macs use? I switch back and forth between the AAO and my MacBook pretty regularly, and it'd be cool to have the same pointer behavior...

mailman1175 wrote:Just curious: Is there a way to enable, on my Acer Aspire One, the two-finger scroll and right-click behavior that Macs use? I switch back and forth between the AAO and my MacBook pretty regularly, and it'd be cool to have the same pointer behavior...

I'm not sure of your equipment's capabilities. You might try gpointing-device-settings, an applet you can install from Synaptic. It has better control over a pointing device than most systems. After installing it use Startup Applications to run it at bootup or terminal to run it otherwise.

I see that I have the xserver-xorg-input-synaptics driver installed. That driver technically has all the capabilities I'm looking for on the hardware that I have, but I don't know where the config file is, nor how to configure it correctly. I'm used to GNOME, where I had a rich GUI front-end for mouse config. Simple Mouse is... well, it's simple. I appreciate the thorough work to make lightweight applications for Fluxbox CE (w00t, kendall!), but in this case, it's not quite enough.

**Edit**

I should be more specific: I would normally edit the xorg.conf file, as that's where the synaptics driver settings are normally kept. But it's not in /etc/X11/, and the only thing Catfish turns up matching xorg.conf is a .gz file in /usr/share/.

So the question is, how do I go about manually editing mouse behavior in Fluxbox?

The newer versions of xorg can run without a config file. If it does not find /etc/X11/xorg.conf it automatically configures the hardware. To make xorg use your configs instead of the automatic ones, create the xorg.conf file and add the configurations you want in the file. Any configs that are not defined in the file will fall back to the default (automatic) ones.