[4gedaboudit!] Lost eth0 after Linux Mint 13 Cinnamon update

Questions about cabled networking
Forum rules
Before you post please read this

[4gedaboudit!] Lost eth0 after Linux Mint 13 Cinnamon update

Postby phr33k on Sat Jan 26, 2013 11:53 am

Linuxmint 13 Cinnamon 32 bit
Dell Inspiron 6400 laptop
Broadcom 440x 10/100 Integrated Controller (ethernet card)
________________________________________________________

I've had Linuxmint 13 Cinnamon installed and running on a Toshiba Canvio 750GB portable HD for months now. It used to work fine and the ethernet was easy to configure and use. I have no router; just an ethernet cable from my laptop to my ADSL modem.

I haven't booted from the portable HD for a while, so when I did boot from it this morning, I got the latest update, and that was a horrible mistake. I'll just talk about the ethernet problem here though.

I apparently lost all the info about my ethernet card (wireless card is disabled). Hope the following helps.
________________________________________________________

contents of /etc/network/interfaces

Code: Select all
auto lo
iface lo inet loopback

________________________________________________________

output from inxi -N command

Code: Select all
Network:   Card-1: Broadcom BCM4401-B0 100Base-TX
           Card-2: Broadcom BCM4311 802.11a/b/g driver: wl

_________________________________________________________

output from ifconfig -a (as root)

Code: Select all
lo        Link encap:Local Loopback 
          inet addr:127.0.0.1  Mask:255.0.0.0
          inet6 addr: ::1/128 Scope:Host
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
          RX packets:548 errors:0 dropped:0 overruns:0 frame:0
          TX packets:548 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:0
          RX bytes:40672 (40.6 KB)  TX bytes:40672 (40.6 KB)

__________________________________________________________

output from nm-tool command

Code: Select all
NetworkManager Tool

State: disconnected

__________________________________________________________

In Network window:

Code: Select all
Wired
Cable unplugged
Hardware Address AA:BB:CC:DD:55:66:77:88

__________________________________________________________

My ethernet connection still works fine everywhere but this Mint installation.
phr33k
Level 1
Level 1
 
Posts: 27
Joined: Fri Feb 17, 2012 5:13 pm

Linux Mint is funded by ads and donations.
 

Re: [4gedaboudit!] Lost eth0 after Linux Mint 13 Cinnamon up

Postby phr33k on Mon Feb 18, 2013 12:52 pm

After being overwhelmed by all the help offered here :cry: and after thinking about all the other problems the update caused, I just formatted the partition and installed Mint 14 Cinnamon. It's too soon to say much about how Nadia works on my portable HD.

I will say that using Linux makes me feel like an alpha tester.
phr33k
Level 1
Level 1
 
Posts: 27
Joined: Fri Feb 17, 2012 5:13 pm


Return to Ethernet

Who is online

Users browsing this forum: No registered users and 3 guests