I have dual boot system Mint 13 / Win7
I've managed to configure my PC for wake-on-lan and it works when the PC has been shut down by WIN7.
When it's been shut down with Mint the PC will not wake up with Magic packet.
I have read a lot about ethtool and I thought I've done everything to properly configure the LAN board.
Here is what "sudo ethtool eth0" gives :
- Code: Select all
Settings for eth0:
Supported ports: [ TP MII ]
Supported link modes: 10baseT/Half 10baseT/Full
Supported pause frame use: No
Supports auto-negotiation: Yes
Advertised link modes: 10baseT/Half 10baseT/Full
Advertised pause frame use: Symmetric Receive-only
Advertised auto-negotiation: Yes
Link partner advertised link modes: 10baseT/Half 10baseT/Full
Link partner advertised pause frame use: Symmetric
Link partner advertised auto-negotiation: Yes
Supports Wake-on: pumbg
Current message level: 0x00000033 (51)
drv probe ifdown ifup
Link detected: yes
So if I understand, WOL is supported because of Supports Wake-on: pumbg
and WOL is enabled because of Wake-on: g
But still I does not wake up. Thought It does when I've shut down with Win7.
What am I doing wrong?