CD burning

Questions about other topics - please check if your question fits better in another category before posting here
Forum rules
Before you post please read this

CD burning

Postby nibsa1242 on Fri Feb 02, 2007 2:41 pm

This is the error out put from the last coaster I burnt. I did this with all the same settings on a cd-rw before I tried it on a cd-r. The rw went flawlessly. It also seems to work in in dummy mode. Please advise.

Code: Select all
cdrecord: Warning: Running on Linux-2.6.17-10-generic
cdrecord: There are unsettled issues with Linux-2.5 and newer.
cdrecord: If you have unexpected problems, please try Linux-2.4 or Solaris.
scsidev: '/dev/hdc'
devname: '/dev/hdc'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
cdrecord: Warning: using inofficial version of libscg (debian-0.8debian2 '@(#)scsitransp.c   1.91 04/06/17 Copyright 1988,1995,2000-2004 J. Schilling').
SCSI buffer size: 64512
cdrecord: This version of cdrecord does not include DVD-R/DVD-RW support code.
cdrecord: See /usr/share/doc/cdrecord/README.DVD.Debian for details on DVD support.
Cdrecord-Clone 2.01.01a03 (i686-pc-linux-gnu) Copyright (C) 1995-2005 Joerg Schilling
NOTE: this version of cdrecord is an inofficial (modified) release of cdrecord
      and thus may have bugs that are not present in the original version.
      Please send bug reports and support requests to <cdrtools@packages.debian.org>.
      The original author should not be bothered with problems of this version.

TOC Type: 0 = CD-DA
Using libscg version 'debian-0.8debian2'.
Driveropts: 'burnfree'
atapi: 1
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'PHILIPS '
Identifikation : 'DVD+-RW SDVD8441'
Revision       : 'PA48'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x0009
Profile: 0x002B
Profile: 0x001B
Profile: 0x001A
Profile: 0x0014
Profile: 0x0013
Profile: 0x0011
Profile: 0x0010
Profile: 0x000A
Profile: 0x0009 (current)
Profile: 0x0008
Profile: 0x0000
Profile: 0x0000
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96R RAW/R16 RAW/R96R
Drive buf size : 1073152 = 1048 KB
FIFO size      : 4194304 = 4096 KB
   4 seconds.   3 seconds.   2 seconds.   1 seconds.   0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Performing OPC...
Sending CUE sheet...
cdrecord: Success. read track info: scsi sendcmd: no error
CDB:  52 01 00 00 00 FF 00 00 1C 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 05 00 00 00 00 0A 00 00 00 00 24 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x24 Qual 0x00 (invalid field in cdb) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 28
cmd finished after 0.001s timeout 240s
cdrecord: Cannot get next writable address for 'invisible' track.
cdrecord: This means that we are checking recorded media.
cdrecord: This media cannot be written in streaming mode anymore.
cdrecord: If you like to write to 'preformatted' RW media, try to blank the media first.
SAO startsec: -11839
Writing lead-in...
Lead-in write time:   27.648s
Writing pregap for track 1 at -150
Starting new track at sector: 0
cdrecord: Success. write_g1: scsi sendcmd: no error
CDB:  2A 00 00 02 B0 93 00 00 1B 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 0C 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x0C Qual 0x00 (write error) Fru 0x0
Sense flags: Blk 0 (not valid)
resid: 63504
cmd finished after 7.212s timeout 200s
cdrecord: A write error occured.
cdrecord: Please properly read the error message above.

write track data: error after 22607424 bytes
Writing  time:  334.923s
Average write speed  15.3x.
Min drive buffer fill was 87%
Fixating...
Fixating time:    0.003s
cdrecord: fifo had 6597 puts and 6534 gets.
cdrecord: fifo was 0 times empty and 4064 times full, min fill was 92%.

nibsa1242
Level 1
Level 1
 
Posts: 4
Joined: Fri Jan 12, 2007 2:31 pm

Linux Mint is funded by ads and donations.
 

Return to Other topics

Who is online

Users browsing this forum: No registered users and 2 guests