I have installed Virtualbox 4.3.12 downloaded from Oracle. When I tried to install Win XP in a VM, I got an error and had to run the command
- Code: Select all
So I did, and all was well, I installed and then used Win XP.
However next time I booted up LMDE, and went to run the Win XP VM, I got same error and had to rerun the command. I've now found it happens every time I boot LMDE and go to use the Win XP VM. Closing Virtualbox and restarting it, does not cause the error.
Is there a (relatively) permanent way I can fix this once-and-for-all (subject to later updates, I accept) ? I mean apart from making sure the command runs every time I boot up LMDE - I can just run it, or make a startup script or modify rc.local, but these are far from elegant solutions.