Hi,
I have examined the md5sums. I tried two different CDs. There is 1 GB RAM.
With both Beta-systems all was running well.
I have got a problem with installing the new 5.0 Release. I click the install icon. After Keyboard Layout there is an information window:
Starting up the partitioner. Then a cryptic window appears with 12 question marks and the no-entry traffic sign. I hit the OK button and the system is running around in a loop.
What is the solution? There a two hdds in the system sda and sdb.
there are the following partitions: sda1 sdb1 sdb5 sdb7 sdb8
sdb2 is the extented container. sdb6 is the swap partition.
Disk /dev/sda: 8455 MB, 8455200768 bytes
255 heads, 63 sectors/track, 1027 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x000ef021
Device Boot Start End Blocks Id System
/dev/sda1 * 1 1027 8249346 c W95 FAT32 (LBA)
Disk /dev/sdb: 41.1 GB, 41174138880 bytes
255 heads, 63 sectors/track, 5005 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes
Disk identifier: 0x000b60fb
Device Boot Start End Blocks Id System
/dev/sdb1 * 1 973 7815591 83 Linux
/dev/sdb2 974 3468 20041087+ 5 Extended
/dev/sdb5 974 1338 2931831 83 Linux
/dev/sdb6 1339 1533 1566306 82 Linux swap / Solaris
/dev/sdb7 1534 2566 8297541 83 Linux
/dev/sdb8 2567 3468 7245283+ 83 Linux
I just tried the same CD with a single hdd system, only one partition sda1. Then this cryptic no-information-message does not appear. Therefore what is wrong with partition assembly?
regards,
Svgt





