Page 1 of 1

No Sound - Sounblaster Audigy 2 - SOLVED!

Posted: Sat Dec 08, 2012 5:59 pm
by itszando
Just installed linux mint 14 today, looks great! The only problem I'm having is that I am not getting sound at all. I tried both the onboard audio and the soundblaster audigy 2 card. I have went in the bios and disabled the onboard audio just as a troubleshooting step from what i've read online. Any help I could get on this issue would be greatly appreciated. Thank You.

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 6:35 am
by mank_in
try in terminal :

Code: Select all

alsamixer
press F6 to select soundcard , if you see something listed MM ( muted) , unmute with "m" key

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 12:01 pm
by aki90
Same problem here. Installed right today, Everything seemed to work perfectly, but... no audio. I've tried unmuting everything in alsamixer, and stuff... but on the "audio" section of the control centre I've noticed that the hardware isn't recognized at all.

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 12:25 pm
by mank_in
execute in terminal :

Code: Select all

cat /proc/asound/cards

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 2:46 pm
by aki90
My problem fixed itself after i updated the software.
Thank you anyway :)

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 2:51 pm
by itszando
Well my hardware is recognized. I went to alsamixer and unmuted "tone" and "3d control - switch" which are now set to 00 and I can't change... not sure if that matters or not.

As far as the other post:
Here is the output of cat /proc/asound/cards

Code: Select all

 0 [Audigy2        ]: Audigy2 - SB Audigy 2 Value [SB0400]
                      SB Audigy 2 Value [SB0400] (rev.0, serial:0x10011102) at 0xa000, irq 17

Re: No Sound - Sounblaster Audigy 2

Posted: Sun Dec 09, 2012 8:30 pm
by mank_in
you can try to installing gnome-alsamixer:

Code: Select all

sudo apt-get install gnome-alsamixer
search from menu and launch: gnome-alsamixer


Turn on "Audigy Analog/Digital Output Jack"

setup master output up to 50%

Re: No Sound - Sounblaster Audigy 2 - SOLVED!

Posted: Mon Dec 10, 2012 1:31 am
by itszando
mank_in wrote:you can try to installing gnome-alsamixer:

Code: Select all

sudo apt-get install gnome-alsamixer
search from menu and launch: gnome-alsamixer


Turn on "Audigy Analog/Digital Output Jack"

setup master output up to 50%
Mank-in... Thanks a lot, that worked like a charm. Thanks to everyone else that helped, i'm now marking this post as solved. The Linux community really is a beautiful thing.