lm-sensors amd phenom no temp displayed

[thederk]

I am new to the Mint side of things and have been out of the Linux game for a few years. Hoping you folks could help me get my lm-sensors install to display the temp of my processor. My eyes are burning from searching the webs.

Setup:
Linux Mint 13 Maya xfce
Proc: AMD Phenom II X4 965
Mem: 16GB DDR3
Mobo: Gigabyte GA-78LMT-USB3

uname -r

Code: Select all

3.2.0-23-generic

sensors output:

Code: Select all

k10temp-pci-00c3
Adapter: PCI adapter
temp1:         +0.0°C  (high = +70.0°C)
                       (crit = +79.0°C, hyst = +77.0°C)

sensors-detect output:

Code: Select all

Now follows a summary of the probes I have just done.
Just press ENTER to continue:

Driver `to-be-written':
  * ISA bus, address 0x228
    Chip `ITE IT8728F Super IO Sensors' (confidence: 9)

Driver `k10temp' (autoloaded):
  * Chip `AMD Family 10h thermal sensors' (confidence: 9)

Note: there is no driver for ITE IT8728F Super IO Sensors yet.
Check http://www.lm-sensors.org/wiki/Devices for updates.

No modules to load, skipping modules configuration.

Unloading i2c-dev... OK
Unloading cpuid... OK

If I remember correctly, the temperature properly displayed while I was running the Live image, but I can't for the life of me get it functioning on my install.

Thank you.