Questions about hardware,drivers and peripherals
Before you post please read this
Installed Elyssa onto my friends computer. It is using the Broadcom 802.11b/g WLAN network adapter. Install goes smooth only problem is there is no way to get internet working on it. the wireless doesn't work and neither does a wired connection. How can i go about getting this to work when there is no way to connect it to internet? thnks
- Level 3
- Posts: 111
- Joined: Sat Apr 12, 2008 1:19 pm
- Location: Taji, Iraq
Which Broadcom card is it? Post the output of lspci
Other than that I can say that Broadcom cards usually requires b43 or ndiswrapper. Try using the restricted drivers manager first, if that does not work, remove it and use ndiswrapper instead.
You're not drunk if you can lie on the floor without holding on.
- Level 6
- Posts: 1255
- Joined: Sun Nov 18, 2007 12:39 pm
- Location: Norway
Hey there for the b43 chipset i normally keep a copy of my /lib/firmware which has all the broadcom items for both my hp laptops, unfortunately i have had to do similar head banging in the past getting it working now all I do on a fresh install is copy in my firmware, i have attached a copy just on the off chance maybe it works you never know...
just in case you need to know this is my wlan adapter
06:00.0 Network controller: Broadcom Corporation BCM94311MCG wlan mini-PCI (rev 01)
- Level 1
- Posts: 1
- Joined: Fri Jun 06, 2008 3:08 am
Users browsing this forum: No registered users and 29 guests