I have a Creative Zen Micro
I'm trying to install a application/driver I found on the net.
It comes in an extractable, .tar.gz
I'm following the install read me text, and the ./configure works in the terminal
but when i run the next two steps
and Make Install
it gives me these errors
make: *** No targets specified and no makefile found. Stop.
make: *** No rule to make target `install'. Stop.
can anyone tell me what I'm doing wrong, I was having the same problem with another .tar.gz file I had. ended up finding it on mintinstall though, so it didn't matter. but this one does. Any help is greatly appreciated.