I have a Rockchip RK27XX based MP5 player that mounted fine in Mint 10. After a fresh install of Mint 11, it no longer mounts. Not only that, it isn't even recognized in gparted.
Other USB devices seem to mount fine, including other personal media players and pendrives.
Below are the relevant lines of dmesg from both Mint 10 and Mint 11.
Anybody have any ideas how to get it to work?
Thanks
Mint 10
128.541679] usb 1-3: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[ 128.541730] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 128.541754] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 206.392040] usb 1-2: new high speed USB device using ehci_hcd and address 4
[ 206.540287] hub 1-0:1.0: unable to enumerate USB device on port 2
[ 206.921361] usb 1-2: new high speed USB device using ehci_hcd and address 5
[ 207.264748] Initializing USB Mass Storage driver...
[ 207.264872] usb-storage 1-2:1.0: Quirks match for vid 071b pid 3203: 600
[ 207.264903] scsi6 : usb-storage 1-2:1.0
[ 207.265092] usbcore: registered new interface driver usb-storage
[ 207.265096] USB Mass Storage support registered.
[ 208.270837] scsi 6:0:0:0: Direct-Access RockChip USBDISK User 1.00 PQ: 0 ANSI: 0
[ 208.271198] scsi 6:0:0:1: Direct-Access RockChip USBDISK SD 1.00 PQ: 0 ANSI: 0
[ 208.274035] sd 6:0:0:0: Attached scsi generic sg6 type 0
[ 208.274457] sd 6:0:0:1: Attached scsi generic sg7 type 0
[ 208.282193] sd 6:0:0:0: [sde] 15917056 512-byte logical blocks: (8.14 GB/7.58 GiB)
[ 208.282199] sd 6:0:0:0: [sde] Assuming Write Enabled
[ 208.282203] sd 6:0:0:0: [sde] Assuming drive cache: write through
[ 208.284586] sd 6:0:0:0: [sde] Assuming Write Enabled
[ 208.284590] sd 6:0:0:0: [sde] Assuming drive cache: write through
[ 208.284598] sde:
[ 208.288508] sd 6:0:0:1: [sdf] Attached SCSI removable disk
[ 208.288937] sd 6:0:0:0: [sde] Assuming Write Enabled
[ 208.288941] sd 6:0:0:0: [sde] Assuming drive cache: write through
[ 208.288945] sd 6:0:0:0: [sde] Attached SCSI removable disk
[ 217.564865] usb 1-3: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[ 217.564919] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 217.564943] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
Mint 11
23.446103] usb 1-3: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[ 23.446155] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 23.446178] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 23.813458] EXT4-fs (sdb6): re-mounted. Opts: errors=remount-ro,commit=0
[ 26.684314] usb 1-3: usbfs: interface 0 claimed by usblp while 'usb' sets config #1
[ 26.684369] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 26.684393] usb 1-1: usbfs: interface 1 claimed by usblp while 'usb' sets config #1
[ 26.735227] EXT4-fs (sdb6): re-mounted. Opts: errors=remount-ro,commit=0
[ 30.856013] eth0: no IPv6 routers present
[ 51.296030] usb 2-5: new high speed USB device using ehci_hcd and address 3
[ 51.475602] usbcore: registered new interface driver uas
[ 51.486431] Initializing USB Mass Storage driver...
[ 51.486578] usb-storage 2-5:1.0: Quirks match for vid 071b pid 3203: 80600
[ 51.486622] scsi6 : usb-storage 2-5:1.0
[ 51.487261] usbcore: registered new interface driver usb-storage
[ 51.487265] USB Mass Storage support registered.
[ 52.485486] scsi 6:0:0:0: Direct-Access RockChip USBDISK User 1.00 PQ: 0 ANSI: 0
[ 52.485978] scsi 6:0:0:1: Direct-Access RockChip USBDISK SD 1.00 PQ: 0 ANSI: 0
[ 52.487232] sd 6:0:0:0: Attached scsi generic sg6 type 0
[ 52.487745] sd 6:0:0:1: Attached scsi generic sg7 type 0
[ 52.489633] sd 6:0:0:1: [sdf] Attached SCSI removable disk
[ 52.489906] sd 6:0:0:0: [sde] 15917056 512-byte logical blocks: (8.14 GB/7.58 GiB)
[ 52.489912] sd 6:0:0:0: [sde] Assuming Write Enabled
[ 52.600045] usb 2-5: reset high speed USB device using ehci_hcd and address 3
[ 52.848049] usb 2-5: reset high speed USB device using ehci_hcd and address 3
[ 52.916052] usb 2-5: USB disconnect, address 3
[ 52.916300] sd 6:0:0:0: [sde] No Caching mode page present
[ 52.916308] sd 6:0:0:0: [sde] Assuming drive cache: write through
[ 52.916601] sd 6:0:0:0: [sde] Attached SCSI removable disk
[ 87.157035] EXT4-fs (sdb2): mounted filesystem with ordered data mode. Opts: (null)
USB mp5 player isn't recognized in Mint 11
Forum rules
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
-
Savta_Simcha
USB mp5 player isn't recognized in Mint 11
Last edited by LockBot on Wed Dec 28, 2022 7:16 am, edited 1 time in total.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
-
Savta_Simcha
Re: USB mp5 player isn't recognized in Mint 11
After I saw that 45 people looked at my post and no one wrote even one idea as to what to do, I came to the conclusion that I have no choice but to re-install Mint 10 and wait patiently to see if Mint 12 will work with my player. So, despite the fact that there as some really nice features in Mint 11, I'm back with Mint 10 and sure enough my personal media player hooks up just fine.