I have tried with two different cheap dongles but not the expensive Epson BT dongle. The dongle plugs into the printer, my laptop has BT built-in
I can send an image to the printer from my laptop (only JPG or TIFF) but cannot print from an application, Gimp for example.
I think what is missing is the Hardcopy Cable Replacement Profile.
Can anyone tell me from the following output if this is possible, thanks
- Code: Select all
~ $ sudo hcitool info 00:15:83:3D:0A:57
[sudo] password for helix:
Requesting information ...
BD Address: 00:15:83:3D:0A:57
Device Name: Stylus Photo R300-0
LMP Version: 2.0 (0x3) LMP Subversion: 0xc5c
Manufacturer: Cambridge Silicon Radio (10)
Features: 0xff 0xff 0x8f 0xfe 0x9b 0xf9 0x00 0x80
<3-slot packets> <5-slot packets> <encryption> <slot offset>
<timing accuracy> <role switch> <hold mode> <sniff mode>
<park state> <RSSI> <channel quality> <SCO link> <HV2 packets>
<HV3 packets> <u-law log> <A-law log> <CVSD> <paging scheme>
<power control> <transparent SCO> <broadcast encrypt>
<EDR ACL 2 Mbps> <EDR ACL 3 Mbps> <enhanced iscan>
<interlaced iscan> <interlaced pscan> <inquiry with RSSI>
<extended SCO> <EV4 packets> <EV5 packets> <AFH cap. slave>
<AFH class. slave> <3-slot EDR ACL> <5-slot EDR ACL>
<AFH cap. master> <AFH class. master> <EDR eSCO 2 Mbps>
<EDR eSCO 3 Mbps> <3-slot EDR eSCO> <extended features>
