Hello everyone,
I installed Linux Mint 12 today, and I have the same problem i had on Ubuntu before.
My laptop is connected on wifi, dhcp get me good ip address (dns, ip, netmask...) but i have not internet.
I tried with two wireless card, same problem. I tried to connect to my neighbor router, all is working.
Do you have a clue please?
mintWifi.py
-------------------------
* I. scanning WIFI PCI devices...
-- Intel Corporation Centrino Wireless-N 1000
==> PCI ID = 8086:0083
-------------------------
* II. querying ndiswrapper...
-------------------------
* III. querying iwconfig...
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11bgn ESSID:"Bbox-9B81B8"
Mode:Managed Frequency:2.462 GHz Access Point: 96:FE:F4:9B:81:B8
Bit Rate=26 Mb/s Tx-Power=14 dBm
Retry long limit:7 RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality=56/70 Signal level=-54 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:47 Missed beacon:0
-------------------------
* IV. querying ifconfig...
eth0 Link encap:Ethernet HWaddr 90:e6:ba:ef:ad:c9
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:0 (0.0 B) TX bytes:0 (0.0 B)
Interrupt:57
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:830 errors:0 dropped:0 overruns:0 frame:0
TX packets:830 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:65988 (65.9 KB) TX bytes:65988 (65.9 KB)
wlan0 Link encap:Ethernet HWaddr 00:1e:64:23:46:at
inet addr:192.168.1.20 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::21e:64ff:fe24:46ec/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:13190 errors:0 dropped:0 overruns:0 frame:0
TX packets:16566 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:12031136 (12.0 MB) TX bytes:2810784 (2.8 MB)
-------------------------
* V. querying DHCP...
Rather than invoking init scripts through /etc/init.d, use the service(8)
utility, e.g. service smbd reload
Since the script you are attempting to invoke has been converted to an
Upstart job, you may also use the reload(8) utility, e.g. reload smbd
-------------------------
* VI. querying nslookup google.com...
;; connection timed out; no servers could be reached
Thank you.






