Wireless dropping out - full signal - BCM4313
Posted: Tue Jan 08, 2013 4:04 pm
My wireless is generally working pretty well, full signal, but under Mint the connection drops repeatedly.
Sometime's it automatically reconnects within a few seconds, sometimes it asks me to confirm the key (WPA2).
I'm using the built-in Broadcom BCM4313 on this laptop.
Here's the listing from lspci -vv
Should I post anything more?
Sometime's it automatically reconnects within a few seconds, sometimes it asks me to confirm the key (WPA2).
I'm using the built-in Broadcom BCM4313 on this laptop.
Here's the listing from lspci -vv
Code: Select all
02:00.0 Network controller: Broadcom Corporation BCM4313 802.11b/g/n Wireless LAN Controller (rev 01)
Subsystem: Broadcom Corporation Device 0587
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 64 bytes
Interrupt: pin A routed to IRQ 17
Region 0: Memory at f0500000 (64-bit, non-prefetchable) [size=16K]
Capabilities: <access denied>
Kernel driver in use: wl
Kernel modules: wl, bcma