All Gurus once were Newbies
There are no such things as "stupid" questions. However if you think your question is a bit stupid, then this is the right place for you to post it. Please stick to easy to-the-point questions that you feel people can answer fast. For long and complicated questions prefer the other forums within the support section.
Before you post please read this
I opened Control Panel and edited screen resolution from 1440x900 to 1600x1024 or so, and changed bit rate from 50 to 75. After applying changes, the window became darkened and I could not see the start button, and hence cannot start programs or close the window, if logged in. Kindly tell me how to change screen resolution and bit rate in command line mode.
- Level 1
- Posts: 1
- Joined: Fri Mar 13, 2009 8:21 pm
On command line hopefully someone else will reply shortly, but have you tried booting into Recovery mode? It should be in your boot menu.
Resistance [to Linux] is futile.
- Level 4
- Posts: 406
- Joined: Mon Dec 04, 2006 4:54 pm
- Location: Ontario, Canada
Users browsing this forum: ayjaydubya, sourcefinder, Steeler [Crawler], sterling silver, trapperjohn, xenopeek and 36 guests