Hah. Me again.
So it is not quite as it should be.
Altough I managed to print few pages since my last visit here, it turned out that it was only my luck. It prints only some of the page then it ignores the rest of it and prints some stuff like:
__________________@PJL SET RESOLUTION=600
____________________________________________@PJL SET DENSITY=5
________________________________________________________________ @PJL SET DUPLEX=OFF
(where ____ are just empty places, but it wont allow me to format my post)
and I was simply lucky that on these few occasions it managed to get right through to the bottom of the page without that stuff.
Now I needed to print 10 copies of something and it went mad, it started to print and never wanted to stop, the cancel button on the printer was not reacting, so I just had to switch it off, but after I switch it on it started to print again, but this time I managed to cancel the printing.
I got about 16 copies of which only three were full pages, the others went from about 1 cm to maybe half of the page and the rest was replaced with the stuff above.
I wanted to show it to you, but then I discovered that my scanner is not working as well...
Swearing has no effect this time...
Any ideas what can I do about it?
EDIT: I noticed that where unknown IPP tag was, in "Other options - advanced" i have "print-color-mode" set to color, and I neither can remove that option, nor switch it to monochromatic, as after clicking "ok" or "apply" it pops up again - just as it was with that IPP tag... So I guess that might be somehow related...
EDIT 2: I tried other drivers available, but the problem seems to be common for all of them. So I installed it back to how it was and also reinstalled the package from you, but I am back to square one: it wont print anything, if I turn it on in settings it will switch off after second or two. Except that there is no unknown IPP tag popup window, but I can't remove that print-color-mode option now where unknown IPP tag used to be...