KILL signals performed on init (LM 14)

Questions about other topics - please check if your question fits better in another category before posting here
Forum rules
Before you post please read this

KILL signals performed on init (LM 14)

Postby FeatherFoot on Tue Jan 08, 2013 12:16 am

Hello LM forums.

(Not sure where to put this, so it's in this subforum. If anyone knows where this would make more sense, please let me know.)

Earlier today, I decided to try the impossible and try to kill init via terminal. Here are the results.

Signal 1(SIGHUP), 3-5 (SIGQUIT, SIGILL, and SIGTRAP), 7-10 (SIGBUS, SIGFPE, SIGKILL, and SIGUSR1), 12-29 (SIGUSR2 to SIGIO), and 31 (SIGSYS, Bad System Call) did absolutely nothing.

Signal 2 (SIGINT, Interrupt) rebooted the system.

Signal 30 (SIGPWR, Power Failure) shut down the system (analogous to the halt command).

Signal 7 (SIGABRT, Process Aborted) and Signal 11 (SIGSEGV, Segmentation Fault/Segment Violation) both caused a kernel panic.

This post is for informative purposes only. I am not responsible for any loss of data by trying any of this. When I did this I had absolutely nothing important to save or anything. If you DO try this, I STRONGLY ADVISE you to save any work you have open.

Also, I am new to these forums. :)
FeatherFoot
Level 1
Level 1
 
Posts: 1
Joined: Tue Jan 08, 2013 12:03 am

Linux Mint is funded by ads and donations.
 

Return to Other topics

Who is online

Users browsing this forum: No registered users and 3 guests