What can I do to connect to my network?
Here is the output from mintwifi:
Code: Select all
-------------------------
* I. scanning WIFI PCI devices...
-------------------------
* II. querying ndiswrapper...
netani : driver installed
device (17CB:0001) present
-------------------------
* III. querying iwconfig...
wlan0 IEEE 802.11g ESSID:off/any
Mode:Managed Channel:0 Access Point: Not-Associated
Bit Rate:108 Mb/s
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
lo no wireless extensions.
eth0 no wireless extensions.
-------------------------
* IV. querying ifconfig...
eth0 Link encap:Ethernet HWaddr 00:13:72:0e:df:cb
inet addr:192.168.2.15 Bcast:192.168.2.255 Mask:255.255.255.0
inet6 addr: fe80::213:72ff:fe0e:dfcb/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:535 errors:0 dropped:0 overruns:0 frame:0
TX packets:581 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:352647 (352.6 KB) TX bytes:97408 (97.4 KB)
Interrupt:17 Memory:fbee0000-fbf00000
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:76 errors:0 dropped:0 overruns:0 frame:0
TX packets:76 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:5994 (5.9 KB) TX bytes:5994 (5.9 KB)
wlan0 Link encap:Ethernet HWaddr 00:11:50:25:06:e7
UP BROADCAST MULTICAST MTU:1500 Metric:1
RX packets:13 errors:0 dropped:13 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:2028 (2.0 KB) TX bytes:0 (0.0 B)
Interrupt:18 Memory:88000000-88080000
-------------------------
* V. querying DHCP...
Rather than invoking init scripts through /etc/init.d, use the service(8)
utility, e.g. service smbd reload
Since the script you are attempting to invoke has been converted to an
Upstart job, you may also use the reload(8) utility, e.g. reload smbd
RTNETLINK answers: File exists
-------------------------
* VI. querying nslookup google.com...
Server: 192.168.2.1
Address: 192.168.2.1#53
Non-authoritative answer:
Name: google.com
Address: 74.125.140.100
Name: google.com
Address: 74.125.140.101
Name: google.com
Address: 74.125.140.139
Name: google.com
Address: 74.125.140.113
Name: google.com
Address: 74.125.140.102
Name: google.com
Address: 74.125.140.138