Target filesystem doesn't have requested /sbin/init
No init found. Try passing init= boottarg.
[ 7.6831851] ohci_hcd: UBB 1.1 'Open' Host Controller (OHCI) driver
BusyBox v1.20.2 (Debian 1:1.20.0-7)built-in shell (ash)
Enter 'help' for a list of built-in commands.
/bin/sh: can't access tty: job control turned off
Dear community total newbie here. I have installed and used Olivia on our laptop and it all went text book perfect. I couldn't find the same disc I used before so downloaded the latest torrent for the debian version of Mint. I presume Petra. Installation also looked slightly different to the first one. It didn't seem to let me do a partition so I ended up formatting the disc. On the initial start up after install I can't get past the above^ dialogue. I did another format and install off the disc but it still stops here so I assume it is hardware conflict of some kind but really have no idea. Hoping some one is around who can help me get my computer working again. TIA
Archived topics about LMDE 1
2 posts • Page 1 of 1
I found the original Olivia 15 (non Debian) disc and installed this along side the LMDE and it installed perfectly and runs perfectly. I went to the LM site to down load a new torrent of the LMDE and when the torrent was about to start there was a message saying that there were invalid files. Could it be that my LMDE disc has invalid files and that is why I cannot run it or boot it? I'd still quite like to run it as the Debian edition so is there a work around this?