I have cloned a hdd of my pc to put in a laptop using clonezilla. The drive is not recognised by the hardware. Source and destination hardwares are both on legacy boot. I managed to boot the new system with Super Grub2 Disk so I could repair grub. Ran:
grub-install /dev/sda
which completed without errors, but system still does not recognise the drive.
Grub install no success
Forum rules
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
Before you post read how to get help. Topics in this forum are automatically closed 6 months after creation.
-
triplemaya
- Level 2
- Posts: 69
- Joined: Tue Nov 29, 2011 9:12 am
Grub install no success
Last edited by LockBot on Wed Dec 28, 2022 7:16 am, edited 1 time in total.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
Reason: Topic automatically closed 6 months after creation. New replies are no longer allowed.
Re: Grub install no success
After the grub install, you have to run:
Code: Select all
sudo update-grubLinux Mint 20.3 (Cinnamon)
Linux Mint 19.3 (Cinnamon)
Bodhi Linux 6.0 (MokshaArcGreen)
Fedora 35 (Cinnamon)
Linux Mint 19.3 (Cinnamon)
Bodhi Linux 6.0 (MokshaArcGreen)
Fedora 35 (Cinnamon)
-
triplemaya
- Level 2
- Posts: 69
- Joined: Tue Nov 29, 2011 9:12 am
Re: Grub install no success
Thanks.
New problem. Since switching off the pc Super Grub2 Disk no longer finds anything to boot too when I switch on again. Any ideas?
New problem. Since switching off the pc Super Grub2 Disk no longer finds anything to boot too when I switch on again. Any ideas?