Page 1 of 1
ATI laptop: Added "splash=0" on install...is that ok?
Posted: Mon Nov 19, 2007 5:17 am
by enchance
On install I pressed F6 to edit my installation and replaced "quiet splash" with "splash=0" and I was able to install Daryna without any probs on my ATI laptop.I wanna know..was that ok?
Posted: Mon Nov 19, 2007 6:25 am
by Husse
OK it was OK
You managed to install....
Not that I know what it does, but it does no harm.
It did not work with quiet splash?
Re: ATI laptop: Added "splash=0" on install...is that ok?
Posted: Tue Nov 20, 2007 12:15 pm
by enchance
No, "quiet splash" didn't even get me as far as the installation GUI where you can select to install/safe graphics mode/1st hard disk--I'd get stuck in the usual white-text-black-background screeen. I had to experiment several times until finally getting it to run with "splash=0". It must have something to do with my ATI card.
It's a good thing it worked, too. A few more install failures and I would've opted to go back to gutsy.