Linux Mint Forums

I just installed Helena on my desktop with a dual boot with XP. The installation of Helena was unable to configure my wireless network card to work. What do I need to do to get it working? Here is the result of lspci:

00:08.0 Network controller [0280]: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller [14e4:4318] (rev 02)
Subsystem: Linksys Device [1737:0042]
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr- Stepping- SERR- FastB2B- DisINTx-
Status: Cap- 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort- <TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 32
Interrupt: pin A routed to IRQ 16
Region 0: Memory at ee010000 (32-bit, non-prefetchable)
Kernel driver in use: b43-pci-bridge
Kernel modules: ssb

Have you read any of this, Ubuntu but should work?

https://help.ubuntu.com/community/WifiD ... er/bcm43xx

MaddogF16 wrote:Have you read any of this, Ubuntu but should work?

https://help.ubuntu.com/community/WifiD ... er/bcm43xx

Dynomite! Thanks for that link. I'll get to it later today and give it a try. I'm a total noob with Linux, so I appreciate people like you who point me in the right direction toward easy to understand instructions.