Kyocera network printer with original PPD not working

Forum rules
Before you post please read this
Post Reply
digiflash
Level 1
Level 1
Posts: 18
Joined: Sat Jan 02, 2016 1:39 pm

Kyocera network printer with original PPD not working

Post by digiflash » Tue Sep 04, 2018 2:21 am

The printer (FS 1128) just prints "Error Name: /undefined" and "Offending Command: ****". "Operand stack" is empty.
I have no idea. Didn't find any advice via Google.

pdc_2
Level 8
Level 8
Posts: 2411
Joined: Mon May 11, 2009 1:21 am

Kyocera network printer unknown model

Post by pdc_2 » Tue Sep 04, 2018 2:12 pm

I have no idea.
.. it is a bit hard for us to have an idea too; could you tell us just a tiny wee bit about what you did please; it would be much appreciated

digiflash
Level 1
Level 1
Posts: 18
Joined: Sat Jan 02, 2016 1:39 pm

Re: Kyocera network printer with original PPD not working

Post by digiflash » Wed Sep 05, 2018 5:27 am

Installed Linux Mint 19. I used the original driver from Kyocera. Installed the printer via assisted setup of Linux Mint 19. Scanned for network printers. Printer wasn't found so I entered the IP manually. Printer was found and set up as "socket:\\xxxxx:9100". In the driver dialog I selected the downloaded PPD from Kyocera (https://www.kyoceradocumentsolutions.eu ... ._.EN.html#). I also tried other included Kyocera drivers of Linux Mint. Didn't work.
On another notebook with Linux Mint 18.3 the driver is working properly.

kieselflink
Level 1
Level 1
Posts: 1
Joined: Fri Sep 07, 2018 7:21 am

Re: Kyocera network printer with original PPD not working

Post by kieselflink » Fri Sep 07, 2018 7:57 am

Same trouble here. Fresh installation of mint 19 mate, orig PPD from kyocera (model fs-3920dn), setting on printer hardware to KPDL, print channel IP:9100...

At printed testpage: "Error Name: /undefined"

PPD runs fine with mint 18.3

:roll:

Post Reply

Return to “Printers & Scanners”