I'm on page 29 of the PDF manual:
http://sites.math.northwestern.edu/reso ... revG_e.pdf
My etc/sane.d/dll.conf file looks like this:
Code: Select all
# /etc/sane.d/dll.conf - Configuration file for the SANE dynamic backend loader
#
# Backends can also be enabled by configuration snippets under
# /etc/sane.d/dll.d directory -- packages providing backends should drop
# a config file similar to dll.conf in this directory, named after the package.
#
# The next line enables the network backend; comment it out if you don't need
# to use a remote SANE scanner over the network - see sane-net(5) and saned(8)
net
abaton
agfafocus
apple
avision
artec
artec_eplus48u
as6e
bh
canon
canon630u
canon_dr
#canon_pp
cardscan
coolscan
#coolscan2
coolscan3
#dc25
#dc210
#dc240
dell1600n_net
dmc
epjitsu
#epson
epson2
epsonds
fujitsu
#gphoto2
genesys
gt68xx
hp
hp3900
hpsj5s
hp3500
hp4200
hp5400
hp5590
hpljm1005
hs2p
ibm
kodak
kodakaio
kvs1025
kvs20xx
leo
lexmark
ma1509
magicolor
matsushita
microtek
microtek2
mustek
#mustek_pp
mustek_usb
mustek_usb2
nec
niash
#p5
pie
pixma
plustek
#plustek_pp
#pnm
qcam
ricoh
rts8891
s9036
sceptre
sharp
sm3600
sm3840
snapscan
sp15c
#st400
#stv680
tamarack
teco1
teco2
teco3
#test
u12
umax
#umax_pp
umax1220u
v4l
xerox_mfp
hpaio
I'm not sure how to "check that the net module is enabled."
My etc/sane.d/net.conf file looks like this:
Code: Select all
# This is the net backend config file.
## net backend options
# Timeout for the initial connection to saned. This will prevent the backend
# from blocking for several minutes trying to connect to an unresponsive
# saned host (network outage, host down, ...). Value in seconds.
# connect_timeout = 60
## saned hosts
# Each line names a host to attach to.
# If you list "localhost" then your backends can be accessed either
# directly or through the net backend. Going through the net backend
# may be necessary to access devices that need special privileges.
# localhost
I'm not sure how to "check that the server I want to use is listed."
My etc/imagescan/imagescan.conf file looks like this:
Code: Select all
# /etc/imagescan/imagescan.conf -- Image Scan configuration
# Refer to the documentation for details on the configuration options
# for the software. Plugins should come with their own documentation
# if they have configuration options.
#
# Lines starting with a # or a ; are comments. Comments must be on a
# line of their own. End-of-line comments are not supported.
[devices]
; myscanner.udi = esci:networkscan://192.168.0.2:1865
; myscanner.vendor = Epson
; myscanner.model = DS-5500
I already noticed for "myscanner.model" is says "DS-5500" instead of "ET-4500". Would changing it to that work? Also, do I have to change the myscanner.udi? How do I do that/find the correct one?