Slimming down my xfce system

[DAMIEN1307]

hi folks...some of you know that i am always on the continual quest of stream lining my xfce OS...i have a feeling that i might just now be there...my system now reports that i am now using 8.1 GB of my hard drive...im also posting my reports on systemd-analyze and systemd-analyze blame as ive also been working on boot-up times as well as how to get an old fashioned WD 500 GB spinner HD to come anywhere near close to the newer SSD drives everyone is raving about now...im also posting my GUFW results for what exactly is running through my firewall at present, (the only missing item from that is the browser because it wasnt active at the time),...let me know if anyone thinks there is room for improvement i have not though of as of yet...DAMIEN

Code: Select all

damien@damien ~ $ systemd-analyze
Startup finished in 2.680s (kernel) + 13.120s (userspace) = 15.801s
graphical.target reached after 13.116s in userspace

Code: Select all

damien@damien ~ $ systemd-analyze blame
          8.176s systemd-journal-flush.service
          6.607s dev-sda1.device
          5.932s ufw.service
          5.794s keyboard-setup.service
          4.903s systemd-udevd.service
          4.115s systemd-sysctl.service
          3.093s plymouth-start.service
          2.350s apparmor.service
          2.119s udisks2.service
          2.081s mintsystem.service
          2.071s NetworkManager.service
          1.836s grub-common.service
          1.639s systemd-modules-load.service
          1.357s accounts-daemon.service
          1.163s networkd-dispatcher.service
           964ms run-rpc_pipefs.mount
           716ms systemd-remount-fs.service
           702ms sys-kernel-debug.mount
           701ms dev-hugepages.mount
           669ms dev-mqueue.mount
           618ms gpu-manager.service
           548ms swapfile.swap
           543ms polkit.service
           527ms upower.service
           457ms lightdm.service
lines 1-25

GUFW Report for only firewall applications
running (yes...im running one in my router as well)

Code: Select all

#   Protocol  Port   Address  Application

1   TCP       111    *        rpcbind

2   UDP       111    *        rpcbind

3   UDP        68    *        dhclient

4   UDP       761    *        rpcbind

[catweazel]

let me know if anyone thinks there is room for improvement...

Enclose your output between [ⅽode] and [/ⅽode] code markers would be a major improvement.

[DAMIEN1307]

yep catweazel...you are correct...my apologies but have a good excuse this time...lol...was having more chest pains again and had to go to the hospital to get checked out...some sort of inflammation issue surrounding some sort of sack around the heart tissue sort of thing, seems to be all it is for now...just need to get some rest i guess...edited and corrected now...thanks for the reminder...DAMIEN