How to bind GNU Assembler to Glade

All Gurus once were Newbies
Forum rules
There are no such things as "stupid" questions. However if you think your question is a bit stupid, then this is the right place for you to post it. Please stick to easy to-the-point questions that you feel people can answer fast. For long and complicated questions prefer the other forums within the support section.
Before you post please read how to get help
Post Reply
Level 1
Level 1
Posts: 19
Joined: Tue Jan 10, 2017 9:32 pm
Location: The Netherlands

How to bind GNU Assembler to Glade

Post by Arikania » Thu Jan 19, 2017 10:56 pm

I use mint 17.1 Cinnamon.

I am not quite sure if it is can be done, but the examples that I found on internet imply that GTK is compiled by GCC. Therefore I assume it should be possible.

My goal is to use Glade to create interfaces for the assembly programs that I write. And, if possible, to create listings that way that show me how to write that GUI directly in an XML style format instead, i.e. omitting Glade.

Is that possible?

I am busy learning about 64 bit x86 assembly for Linux at the moment, but I haven't quite figured out how to use Glade yet.

Post Reply

Return to “Newbie Questions”