Just installed Mint 11 (LMDE/XFCE). Been a long time Ubuntu user. I seem to connect to internet but I cannot access a single webpage. Ping and wget both fails. I am a BSNL Boradband user (India), using a router that requires a username and password to connect to internet. I used to configure my Ubuntu systems with "sudo pppoeconf". This time with Mint, I did the same (I guess everything is the same since it's based off Debian). While in Ubuntu, I used to say "yes" to automatically update /etc/resolv.conf but recently I read in Arch wiki that while using a router, resolv.conf should point to router's IP. So now my resolv.conf looks like:
Code: Select all
# Generated by NetworkManager
domain local.lan
search local.lan
nameserver 192.168.1.1
Code: Select all
eth1 Link encap:Ethernet HWaddr 00:e3:74:27:03:3c
inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::2e3:74ff:fe27:33c/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:988 errors:0 dropped:0 overruns:0 frame:0
TX packets:1284 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:92982 (90.8 KiB) TX bytes:134096 (130.9 KiB)
Interrupt:18 Base address:0xc800
lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:605 errors:0 dropped:0 overruns:0 frame:0
TX packets:605 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:904503 (883.3 KiB) TX bytes:904503 (883.3 KiB)
ppp0 Link encap:Point-to-Point Protocol
inet addr:117.194.64.231 P-t-P:117.194.64.1 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MULTICAST MTU:1460 Metric:1
RX packets:278 errors:0 dropped:0 overruns:0 frame:0
TX packets:3 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:3
RX bytes:20615 (20.1 KiB) TX bytes:30 (30.0 B)
Code: Select all
Trying 192.168.1.1...
Connected to 192.168.1.1.
Escape character is '^]'.
<snip>
Welcome to ISOS10.0-SR4
Login: Trying 192.168.1.1...
Connected to 192.168.1.1.
Escape character is '^]'.
<snip>
Welcome to ISOS10.0-SR4
Login:
Code: Select all
sudo route add default gw 192.168.1.1
Code: Select all
sudo pon dsl-provider
Regards