First, I would like to state my gratitude to all the active forum members, constantly helping out - I am new to Linux myself, however I could figure out and find most of the questions I had so far, therefore my thanks.
The stated problem however, even though similar to some posts I saw on this forum, is a bit different and cannot quite figure it out by own.
Basically, I need to switch the default port of PulseAudio, as it changes after every reboot.
After every reboot "Speaker" is selected, but I always need to change it manually to "Headphones"
The thing is, (as I assume) it is a subdevice not listed in the sink list, it is however present in the PulseAudio option
Code: Select all
**** List of PLAYBACK Hardware Devices ****
card 0: sofhdadsp [sof-hda-dsp], device 0: HDA Analog (*) []
Subdevices: 0/1
Subdevice #0: subdevice #0
card 0: sofhdadsp [sof-hda-dsp], device 1: HDA Digital (*) []
Subdevices: 1/1
Subdevice #0: subdevice #0
card 0: sofhdadsp [sof-hda-dsp], device 3: HDMI1 (*) []
Subdevices: 0/1
Subdevice #0: subdevice #0
card 0: sofhdadsp [sof-hda-dsp], device 4: HDMI2 (*) []
Subdevices: 0/1
Subdevice #0: subdevice #0
card 0: sofhdadsp [sof-hda-dsp], device 5: HDMI3 (*) []
Subdevices: 0/1
Subdevice #0: subdevice #0